Installing Glass Tile

installing_glass_tile

We will install glass tile today. I will teach you how will you install install glass tile.

The Tools You Will Need

*A 3/16 inc Trowel

*A grout float

*A sponge Float

* The Knippers

The beginingof every installition faith starts with a unpacking of the mosaics. It is allways useful to verify the condition of the cheetah mosaics contained in the boxrs before beginning to install. This tutorial shows glass mosaic being installed but it is the same procedure for marble mosaics or ceramic. The only diffirence is the moral ceramic are usually mounted in the back with fiberglass netting. It is also good practice to keep the material to be laid at the same temparatures surrounding cs in which the work is being carried out .

Starting point is that identified and marked on the wall where the mosaic sheets are to be late.Markan level the guidelines at right angles to each other corresponding to the multiples of sheets of mosaics previously measured. It is usually a good idea to marco off squares for one or two sheets of course in the case of wall installation has in this tutorrial guidelines must be horizantal and vertical. Once the refference group has been more the adhesive which is a polymer modified thin setavailable at home depot and lowsis spread over the work area getting it very close to the work lines you have marked, but not covering them so that you can place the tiles right on the lines. First apply the visa with the smallest part of the nudged trial to ensure the whole surface is covered. Excessive cheeses then removed with the peanuts part of the trial being careful keep a steady fortyfive degree angle and exerting sufficient pressure or so that no more attorneys have been necessary remains on the base. After the yet it has been spread over the base begin by applying mosaic sheet with the plastic film towards you and without exerting too much pressure as they are installed lightly tapped them with the flat sponge trial or float to set them firmly in the end he said. During the installing some manual moving of the sheets of mosaics may be necessary. Any cuts can be done with using the tile net proves you can install them during the laying of the four sheets but a better idea is to waait until the four sheets are dry. This gives you time to make the best cut you can. After the installing the cuts then wait until they are completly dry before growing. Plastic film is removed the mosaic when the adhensive is sufficiently harden suggested time of approximately three hours. This action shoul be carried out in a bad nonsense keeping the film parallel to the tiles rhemselves. If during the removal of the film the mosaic should move that will be necessary to wait longer for the mosaic to set up. Groaning! respecting the minimum times for setting up to adhesive twenty four hours from vertical walls in fourtyeight hours  for forced to allow them to be walked on then proceed with filling of the grout joints mix the unscented groud according to manufactures suggestions using a rubber float spread the grounding cement with vertical and horizantal strokes exerting a slight pressure to make sure the joints are well filled. Past the grow float diagonally to remove most of the excess filling.

Final Cleaning: cleaning of the surface can begin once the grouding cement start setting the time-varying according to the temparature of the surroundings but it is somewhere between thirty and sixty minutes. Remove the excess grout using a dampened sponge at all times becouse will not remove the drop from the joints. It is very important carry out this operation before the grounding has completly hardened. After the gratis completly dried twenty four to thirty six hours. An eventual residue can be removed with a special asset based product for removing cement residue available at all major home and garden stores

Leave a Reply

Your email address will not be published. Required fields are marked *